2024年4月11日发(作者：)

地面岩板薄贴施工工艺流程

英文回答：

Ground Rock Slab Thin Bonding Construction Process.

1. Substrate preparation.

2. Spreading the adhesive.

3. Laying the ground rock slab.

4. Pressing the ground rock slab.

5. Grouting the joints.

6. Curing.

Substrate preparation.

The substrate should be level, smooth, and free of any

contaminants. Any unevenness in the substrate must be

leveled out using a self-leveling compound. The substrate

must also be primed with a bonding agent to ensure a strong

bond between the adhesive and the substrate.

Spreading the adhesive.

The adhesive should be spread evenly over the substrate

using a notched trowel. The thickness of the adhesive

should be sufficient to ensure full coverage of the

substrate and to provide a strong bond between the adhesive

and the ground rock slab.

Laying the ground rock slab.

The ground rock slab should be laid on the adhesive and

pressed into place. The ground rock slab should be laid in

a staggered pattern to avoid any weak points in the

installation.

Pressing the ground rock slab.

After the ground rock slab has been laid, it should be

pressed into place using a roller or a tamp. This will

ensure that the ground rock slab is fully bonded to the

adhesive and that there are no air pockets beneath the

ground rock slab.

Grouting the joints.

The joints between the ground rock slabs should be

grouted using a grout that is specifically designed for use

with ground rock slabs. The grout should be applied using a

grout float and should be worked into the joints until they

are completely filled.

Curing.

The grout should be allowed to cure for the time period

specified by the manufacturer. During this time, the

installation should be protected from moisture and traffic.

中文回答：

地面岩板薄贴施工工艺流程。

1. 基层处理。

2. 铺贴胶涂抹。

3. 放置岩板。

4. 压实岩板。

5. 填缝剂灌浆。

6. 保养。

基层处理。

基层应平整、光滑、无任何污染物。基层的不平整处必须使用

自流平水泥找平。基层还必须涂刷界面剂以确保粘合剂与基层之间

粘结牢固。

铺贴胶涂抹。

应使用齿形刮刀将粘合剂均匀地涂抹在基层上。粘合剂的厚度

应足够，以确保基层完全覆盖并提供粘合剂与岩板之间的牢固粘结。

放置岩板。

岩板应放置在粘合剂上并压实到位。岩板应错位放置，以避免

安装中的任何薄弱环节。

压实岩板。

岩板放置后，应使用滚筒或夯实机压实到位。这将确保岩板与

粘合剂完全粘结，并且岩板下方没有气穴。

填缝剂灌浆。

岩板之间的接缝应使用专为岩板设计的填缝剂进行灌浆。填缝

剂应使用填缝刀涂抹，并进行填塞，直至接缝完全填满。

保养。

填缝剂应在制造商规定的时间内进行固化。在此期间，安装应

免受潮湿和人流的影响。